Bandimex Band in plastic dispenser – SS-CrNi

versions:
Read more
Read more
Read more
Read more
Read more
Read more
Read more
Read more
Cat.No.: B 803, B 804, B 805, B 806, B 803/50, B 804/50, B 805/50, B 806/50

Description

material

SS-CrNi

packing unit

1 roll

width

12,7 mm – 12″, 16,0 mm – 58″, 19,0 mm – 34″, 9,5 mm – 38

thickness

0,64 mm – .025″, 0,75 mm – .030″

length

30 m

colour

blue, grey, yellow

width thickness Colour of DispenserCat.No.
30 m/roll
weightCat.No.
50 m/roll
weight
9,5 mm – 380,64 mm – .025″yellowB 8031,7 kgB 803/502,7 kg
12,7 mm – 120,75 mm – .030″yellowB 8042,5 kgB 804/504,0 kg
16,0 mm – 580,75 mm – .030″greyB 8053,1 kgB 805/505,0 kg
19,0 mm – 340,75 mm – .030″blueB 8063,6 kgB 806/505,8 kg

Instruction Band and Buckle

Montageanleitung Band und Schlaufen - Step 1Pull buckle on band, ears pointing towards end of band. Form clamp, holding band on band, then push buckle back over the doubled band, bending the end approx. 1″ under buckle.

Montageanleitung Band und Schlaufen - Step 2For heavy duty jobs double wrap band.

Montageanleitung Band und Schlaufen - Step 3Place band in tool, push down on gripper with thumb, tension clamp by turning handle. Maximum tension is reached when band stops moving through buckle.
When required tension has been applied, roll tool over buckle, at the same time reversing handle carefully approx. half turn to avoid breakage. There is no loss of tension, if handle is not reversed too much.

Montageanleitung Band und Schlaufen - Step 4Pull on cutter lever, band is cut off to correct length.

Montageanleitung Band und Schlaufen - Step 5Hold stub of band with thumb, hammer it flat over bridge of buckle, complete clamp by hammering ears over stub.

Montageanleitung Band und Schlaufen - Step 6

to apply with following products: